L2TP/IPsec on Android

From PFSenseDocs
Jump to: navigation, search

The L2TP/IPsec client on Android has the ability to set a custom identifier, which allows L2TP/IPsec to function with pfSense's server using Pre-Shared Keys. Clients on other operating systems do not allow for this, which makes them incompatible with current versions of pfSense.

IPsec Setup

The setup is similar to a standard IPsec Road Warrior/Mobile Client How-To setup except that xauth is not used, but rather "Mutual PSK", and Phase 2 uses Transport mode rather than Tunnel.

Pre-Shared Keys

After the tunnel has been configured, click to the "Pre-Shared Keys" tab in the IPsec settings, and add IPsec keys. A single group key may be used if desired, or make many keys for different users.

That's it for IPsec!

L2TP Setup

To setup L2TP navigate to VPN > L2TP

  • Select Enable L2TP Server
  • Interface is WAN (or the same chosen for IPsec)
  • Server Address is an unused IP address in a new subnet. It MUST NOT overlap any IP in use on the firewall, e.g x.x.x.2
  • Remote Address Range is the starting IP of the clients, e.g. x.x.x.128
  • Subnet netmask is the netmask for the client connection, the server IP should be included in this subnet, e.g. /24
  • Secret should be left blank, it does not appear to work, at least with the Android version tested.
  • Encryption Type: CHAP is recommended
  • L2TP DNS Servers: The firewall's actual LAN IP, or another internal DNS server
  • RADIUS settings - if needed, use them, otherwise leave them alone
  • Save
  • Flip to the Users tab and add L2TP user accounts and passwords there
  • Now go to Firewall > Rules on the L2TP VPN tab, and add a firewall rule to pass traffic, e.g from any to any or much more restrictive if preferred.

Android Client Setup

On the phone/tablet/device:

  • Go to the system settings and VPN settings (varies by device and specific Android version
  • Tap Add VPN Profile
  • Enter a name
  • For Type, tap L2TP/IPsec PSK
  • Server Address: The WAN IP of pfSense (or the IP of the interface chosen for IPsec and L2TP)
  • L2TP Secret: Left blank
  • IPsec Identifier: Enter the identifier for the PSK entered above, either a per-user or common identifier
  • IPsec Pre-Shared Key: The PSK that goes with the identifier for this user/group
  • The advanced options may be used to control which networks will attempt to use the VPN, or specify custom DNS server and domains for this client.
  • Tap Save
  • From the VPN list, tap the newly created VPN entry
  • Enter the username and password from the L2TP Users tab entered above
  • Check Save account information to save the VPN credentials (not recommended!),
  • Tap Connect

The connection should then connect and function. If it does not work, check the IPsec logs and the Status > System Logs, VPN, L2TP Raw log to see more specific errors.

Other Thoughts

In theory, Mutual RSA should also work, but so far it has not succeeded in testing. In RSA mode, Phase 1 requires main mode, but otherwise should be OK.